Recall that entrelac knitting is knitting with modules (I'll call them squares): small patches of knitting that are either (a) preliminary modules that are unattached to other modules (except by a thread), such as the first row of triangles in traditional entrelac, or (b) subsequent modules that are attached to other modules.
The essence of entrelac is that while you knit you are attaching squares at right angles to previously knit squares. This creates a pleasing effect of strips of knitting that are interlaced, woven together, but without the double-thickness of real interlaced strips of knitting. The only double-thickness in regular entrelac comes when you are joining one square to another. This began to bother me… I was able to figure out the neatest way to pick up stitches for one square from the side edge of another, but not to do the other kind of join, where you are attaching the square-in-progress to another square's live stitches. I eventually solved the puzzle, and while the technique isn't as easy, I believe the results are worth the modicum of extra effort.
I generally start an entrelac square by picking up from an exposed side edge of a previous square. Here is the pickup I use:
The other attachment used in entrelac is done while you knit the square. You attach alternate (or two consecutive) rows of the current square to a live stitch from a previous square. Generally this is done as a decrease… knit to the end of a row to the last stitch and do a decrease using the last stitch of the row and a stitch being held on the needles from a previously made square.
I prefer another way of attaching the side edge as I go, and it’s an adaptation of the “sliding-loop” technique Ric Mondragon first put forth in Knitter's Magazine of February, 1995. He uses the technique for joining strips of knitting parallel to each other as in intarsia, and I use it for joining squares of knitting perpendicular to each other.
While working on Square B, join it to Square A (which is not usually the square you just finished) as follows: On B, work to the end of the row and *work one more stitch from the left needle (off the held live stitches of Square A). Take that “one more” stitch, the loop that was just formed, off the right needle, and open it up by pulling yarn through it to enlarge the loop, and use the yarn of that loop to work back and forth over two consecutive rows, pulling through extra yarn as needed. Then, when the two rows are done being worked, pull the excess yarn back through the “one more” stitch. Repeat from * until all the live stitches are from the Square A have been used. When you have used up all of the live stitches from A, you have worked just enough rows to complete B… no need to count rows…. Yay.
Here is Jolie Elder's video demonstrating the join… she explains it better than I can!
This gives a join that is geometrically the same as the “perfecting the perpendicular pickup” technique. Adds to the magic of your knitting, which is somewhat subliminal, but it’s nice when there’s more symmetry for your efforts.
There are some nice effects that you can do once you know this join. True reversibility in entrelac is possible, and I’ve designed and made several hats that use a ribbed or other motif for entrelac, and they look good on both sides. Note that these hats use only knit and purl stitches. The light-green hat looks like it's cabled, but it isn't. Some really nice relief effects happen with these techniques.
 |
| Four reversible-entrelac hats |
When a reverse-stockinette square joins a regular stockinette square at right angles, the join is smooth… on both sides… and this is true with both the picking-up join and the sliding-loop one. Magic!
No comments:
Post a Comment